Plastools Indexable 

Carbide Milling Cutters
NEW!!!!!   WE HAVE 1/2" End Mills That Use

 The TNMG-222 Insert!!

FOR Just an introductory PRICE OF $35.00!!!!!

 

     Here is one of our single fluted end mills with a 3/4" or 5/8" Weldon  shank. It uses the same six point insert that our 322 series lathe tools use, the TNMG-322. This is one of our "Best " values for " Cost Effectiveness" .It sells for $40.00 each with one insert and an allen wrench. So for the first $40.00 purchase plus shipping our tool equals six HSS end mills then for the purchase price of ONE insert you get six more end mills and so on and so on. We believe that this will be one of the best values  on the market. This also goes for our NEW 1/2" end mill that uses the TNMG-222 Indexable Carbide insert and sells for $35.00 each.

     Here is our 15 degree 2" nominal Face mill. It uses three TNMG-322 inserts. Look at those perfect chips!!  Again we are producing our  face mills in limited production at this time. They sell for $125.00 each with three inserts and 1 allen wrench. 

10 Pack TNMG- inserts C-6 $40.00 

 

    

Hit Counter